Plumbing Bradford White Residential Water Heaters | 75 Gallon – 76,000 Btu High Input Atmospheric Vent Energy Saver Residential Water Heater (Nat Gas)

Features:

• Bradford White Icon System – Intelligent Gas Control With Proven Millivolt Powered Technology And Built-In Piezo Igniter. A Standard, Off The Shelf Thermopile Converts Heat Energy From The Pilot Flame Into Electrical Energy Tooperate The Gas Valve And Microprocessor. No Need For External Electricity.
• Enhanced Performance – Proprietary Algorithms Provide Enhanced First Hour Delivery Ratings And Tighter Temperature Differentials.
• Advanced Temperature Control System – Microprocessor Constantly Monitors And Controls Burner Operation To Maintain Consistent And Accurate Water Temperature Levels.
• Intelligent Diagnostics – An Exclusive Green Led Light Prompts The Installer During Start-Up And Provides Ten Different Diagnostic Codes To Assist In Troubleshooting.
• Pilot On Indication – Flashing Green Led Provides Positive Indication That Pilot Is On.
• Separate Immersed Thermowell – High Strength Advanced Polymer Composite Thermowell Provides Isolation Between Electric Temperature Sensor And Surrounding Water. No Need To Drain The Tank When Removing Gas Valve.
• Factory Installed Hydrojet 2 Total Performance System – Cold Water Inlet Sediment Reducing Device Helps Prevent Sediment Build Up In Tank And Increases First Hour Delivery Of Hot Water.
• Vitraglas® Lining – Bradford White Tanks Are Lined With A Exclusively Engineered Enamel Formula That Provides Superior Protection From The Highly Corrosive Effects Of Hot Water. This Formula (Vitraglas®) Is Fused To The Steel Surface By Firing At A Temperature Of Over 1600ºf.
• Side Connections – 3/4″ Npt Tappings That Allow Easy Connections For Space Heating Applications (Potable Water Only).
• Non-Cfc Foam Insulation – Covers The Sides And Top Of Tank, Reducing The Amount Of Heat Loss. This Results In Less Energy Consumption, Improved Operation Efficiencies And Jacket Rigidity (M-I-75 Has 1-1/4″ And M-I-100T Has 2″).
• Pedestal Base.
• Water Connections – Factory Installed True Dielectric Fittings Extend Water Heater Life And Eases Installation.
• Hand Hole Cleanout – Allows Inspection Of Tank Interior And Facilitates The Removal Of Sediment Deposits (M-I-100T Models Only).
• Protective Magnesium Anode Rod.
• 4″ “Snap Lock” Draft Diverter.
• T&P Relief Valve – Included.
• Brass Drain Valve – Tamper Proof Design.