Plumbing Bradford White Heat Pump Water Heaters | 72 Gallon – 76,000 Btu Combi2 Ttw Power Vent Energy Saver Residential Water Heater (Nat Gas)

Features

• Internal Single Wall Heat Exchanger – 1-1/2″ O.D. Glass Coated (Vitraglas) Steel Coil.
  • – 3/4″ Npt Solar Collector Supply And Return Connections
• Low Heat Exchanger Head Loss – Up To 8 Gpm Flow, With Less Than 6 Ft. Ofhead Loss. Greatly Reduces The Required Pump Size For Heat Exchange.
• Integrated Mixing Device – Features An Accurate, Easy To Use Hand Wheel Foradjusting Mixed Water Temperature, A Pre-Piped Stainless Steel Flexible Connectorfor Quick Installation As Well As Optional Water Connections (1/2″ Npt Recirculationinlet, 1/2″ Npt Hot Water Outlet, 1/4″ Npt Cold Water Outlet). This Required Systemis Easily Installed And Ensures A Comfortable Outlet Temperature While Providing Asteady Flow Of Hot Water.
• Honeywell Self Diagnostic Electronic Gas Control – Intelligent Gas Controlwith Spark To Pilot Ignition System Eliminates The Constant Burning Pilot. Thisresults In Savings Of Pilot Gas During Stand By Periods (120 V.A.C.).
  • Enhanced Performance – Proprietary Algorithms Provide Enhanced First Hourdelivery Ratings And Tighter Temperature Differentials.
  • Advanced Temperature Control System
  • Microprocessor Constantly Monitorsand Controls Burner Operation To Maintain Accurate Water Temperature Levels.
  • Intelligent Diagnostics – An Exclusive Green Led Light Prompts The Installerduring Start-Up And Provides Ten Different Diagnostic Codes To Assist Introubleshooting.
• Factory Installed Hydrojet 2 Total Performance System – Cold Water Inletsediment Reducing Device Helps Prevent Sediment Build Up In Tank. Increasesfirst Hour Delivery And Minimizing Temperature Build Up In Tank.
• Vitraglas Lining – Bradford White Tanks Are Lined With An Exclusivelyengineered Enamel Formula That Provides Superior Tank Protection From Thehighly Corrosive Effects Of Hot Water. This Formula (Vitraglas) Is Fused To Thesteel Surface By Firing At A Temperature Of Over 1600°F (871°C).
• Horizontal And Vertical Venting – With 3″ Or 4″ Pvc, Abs Or Cpvc(Maximum Equivalent Vent Lengths On Reverse Side).
• 2″ Non-Cfc Foam Insulation – Covers The Sides And Top Of Tank, Reducing Theamount Of Heat Loss. This Results In Less Energy Consumption, Improvedoperation Efficiencies And Jacket Rigidity.
• Pedestal Base.
• Water Connections – 3/4″ Npt Factory Installed True Dielectric Fittings.
• Two Protective Anode Rods.
• T&P Relief Valve – Installed.
• Low Restriction Brass Drain Valve – Durable Tamper Proof Design.